Red Rock Consulting

Red Rock Consulting, an Oklahoma geotechnical engineering firm

Archive for October, 2010

October Employee of the Month

Oct 29

Posted by kkb in Company Info | Comments off

    
Michaela's First Day on the Rig

Michaela's First Day on the Rig

Michaela Varnier, EI joined the Red Rock Consulting team as a Project Specialist in October of 2010.  She is a graduate of Oklahoma University with both a Bachelors and a Masters of Science in Civil Engineering.  Her Masters thesis research concentrated on colorimeter testing of sulfate rich soils. 

Since joing RRC, Michaela has been busy learning about drilling rigs and field testing, including dilatometer testing.  In the office, Michaela is learning about different aspects of project management, data analysis and report writing.  Michaela has already established herself as a valuable asset. 
 
Welcome, Michaela!  Keep up the GREAT work!
Michaela Varnier (RRC) in McAlester, OK 

Michaela on a project site in McAlester, OK

Dilatometer Arrives

Oct 6

Posted by kkb in Company Info | Comments off

Attaching Drill Rod to the Dilatometer

Attaching Drill Rod to the Dilatometer

Adam Bench with GP&E out of Gainsville, Florida, delivered the new dilatometer equipment to our project site in Walters, Oklahoma on October 5, 2010.  Adam stuck around to introduce us to the equipment setup, measurement procedures and analysis software.  After a rough start (who knew moisture could get into a nitrogen tank?!), the project went relatively smoothly.  After a hard day at work, Adam was treated to an outing in Lawton, Oklahoma with DSO and RRC. 

  
Brad Bettes (DSO), Todd SImpson (DSO), Kristi Bumpas (RRC) and Adam Bench (GP&E) in Lawton, Oklahoma

Brad Bettes (DSO), Todd SImpson (DSO), Kristi Bumpas (RRC) and Adam Bench (GP&E)

 

 

 

 

 

 

 

 

 

 

The Marchetti flat dilatometer test (DMT) providesa a rational, inexpensive method to determine the engineering parameters for the design of earthworks and structural foundations.  The test is performed insitu by pushing into the soil a blade-shaped probe that has an expandable membrane on one side.  Stopping at depth intervals as close as 6 inches, the operator performs the DMT by expanding this membrane.  From the data the engineer can obtain a stratigraphic profile of commonly used soil engineering properties for analysis.  These include soil type, shear strength, deformation modulus, preconsolidation stress, insitu horizontal stress, insitu porewater pressure and the  rate of consolidation in soils ranging from coarse sands to clays.  (Federal Highway Administration “Guidelines for Using the CPT, CPTU and Marchetti DMT for Geotechnical Design”, FHWA-PA-87-024+84-24 Volume III, US Department of Transportation, Washington, DC, 1988)

 

Dilatometer Gauges

Dilatometer Gauges